Routines and basics

Why Does My Skincare Pill? Causes and How to Stop It

Pilling is when skincare or sunscreen rolls into little balls. The causes are film-forming ingredients, too much product, no drying time and rubbing.

Why Does My Skincare Pill? Causes and How to Stop It
On this page

Pilling is when a product you've applied rolls up into small balls or flakes as you put the next layer on top. It isn't your skin peeling, and it doesn't mean the products are bad. It means something has formed a film on the surface that the next product, or your fingers, has lifted off. It's fixable, nearly always by using less, waiting longer, or changing the order.

Is it pilling or peeling?

Pilling Peeling skin
What it is Product rolling off Dead skin flaking off
Colour White, grey or the colour of your product Translucent or skin-coloured
Feel Rubbery or gummy little balls Thin, dry flakes
When As you apply the next layer Any time; worse after retinoids, acids or sunburn
Washes off Completely No

If it's peeling, see retinol burn and over-exfoliating.

Why it happens

1. Film-forming ingredients

Some ingredients are designed to sit on the surface and form a film. That film gives a smooth feel, holds water in, or keeps sunscreen in place. Disturbed before it's set, or loaded with another film on top, it balls up.

The usual suspects:

  • Silicones: dimethicone, dimethicone crosspolymer, cyclopentasiloxane
  • Thickeners and gelling agents: carbomer, acrylates copolymers, xanthan gum, cellulose
  • Film-forming humectants: high-molecular-weight hyaluronic acid, polyglutamic acid
  • Sunscreen film-formers that give water resistance
  • Mineral filters and pigments: zinc oxide, titanium dioxide, iron oxides, talc, mica
  • Some niacinamide serums thickened with gums

None of these is a bad ingredient. They're just more likely to pill when layered.

2. Too much product

More product than the skin can take leaves an excess on the surface, with nothing to hold onto. This is the commonest cause, and the easiest to fix.

3. Not enough drying time

Applying the next layer while the last is still wet smears both.

4. Rubbing

Vigorous rubbing, back-and-forth motion, or going over the same spot rolls the film off.

5. Too many layers

Every extra product is another film. Five or six layers are far more likely to pill than three.

6. Incompatible products

Water-based over oil-based, or a water-based foundation over a silicone-heavy sunscreen, can separate and ball up.

7. A surface that isn't smooth

Dry flakes and dead-cell build-up give products something to catch on.

Free toolSkincare routine builderNot sure what order to use your products in?Open the routine builder →

How to stop it

Use less

Two to four drops of serum, a pea of retinoid, a blueberry of moisturiser. See how much skincare product to use.

Sunscreen is the exception: you still need half a teaspoon. Apply it in two thin layers instead, letting the first set.

Wait

  • 30 seconds to a minute between serums
  • A minute or two after moisturiser
  • Three to five minutes after sunscreen before makeup

Pat, don't rub

Press products in with flat fingers or palms. Apply makeup with a damp sponge, in a bouncing motion.

Cut the number of layers

In the morning especially: one serum, moisturiser, sunscreen. If your sunscreen is moisturising, skip the moisturiser.

Check the order

  • Thinnest to thickest.
  • Water-based before oil-based.
  • Film-formers late: polyglutamic acid and silicone-heavy products after watery serums.
  • Sunscreen last.

See how to layer skincare.

Match your bases

Silicone-based sunscreen or primer with silicone-based foundation. Water-based with water-based. See skincare before makeup.

Smooth the surface

Gentle chemical exfoliation once or twice a week removes the flakes that products catch on. See how often to exfoliate.

Apply to slightly damp skin

Hydrating serums and moisturisers spread thinly and absorb better on damp skin. Don't do this with retinoids or acids.

Finding the culprit

If the general fixes don't work, find which product is responsible.

  1. Test on the back of your hand. Apply your products in order, with your usual waiting time. Rub gently. If it pills there, it's the products, not your face.
  2. Remove one product at a time from your routine for a day each.
  3. Test pairs. Often it's a particular combination: this serum under that sunscreen.
  4. Swap the suspect for something with a different base.

The product that pills isn't always the one causing it. A sunscreen may ball up because of the serum underneath.

Related guideSkincare Before Makeup: The Right Order, and How to Stop It PillingThe order to apply skincare, sunscreen, primer and makeup, how long to wait between layers, and how to prep oily, dry and textured skin so makeup sits well.Read the guide →

Common pilling combinations

Combination Fix
Niacinamide serum under sunscreen Use less; let it dry; or move niacinamide to the evening
Hyaluronic acid serum under silicone moisturiser Apply to damp skin; use less; wait
Mineral sunscreen over a rich cream Lighter moisturiser, or skip it; apply sunscreen in two thin layers
Vitamin C suspension under anything Use a small amount; let it set; or mix with moisturiser if the brand allows
Silicone primer under water-based foundation Match the bases
Several serums at once Pick one for the morning
Reapplying sunscreen over makeup Blot first; press on with a sponge. See how to reapply sunscreen

Does pilling mean the product isn't working?

Partly. Whatever has rolled off isn't on your skin. For most products that's a small loss. For sunscreen it matters, because gaps in the film are gaps in your protection. If your sunscreen pills every time, change the routine underneath it, or change the sunscreen.

If nothing helps

Some products simply don't layer well with others. If you've used less, waited, patted and reordered, and one product still pills, replace it with a different formula. You're looking for a different base: a water-based gel instead of a silicone one, or the reverse.

A morning routine that rarely pills

  1. Cleanse, or rinse
  2. One thin, watery serum, two or three drops, pressed in
  3. Wait a minute
  4. A light moisturiser, or none
  5. Wait a minute
  6. Sunscreen in two thin layers
  7. Wait three to five minutes
  8. Makeup, pressed on

The routine builder puts your products in a sensible order.

FAQs

Why does my skincare ball up?

Usually too much product, too little drying time, rubbing, or film-forming ingredients layered on each other.

How do I stop my sunscreen pilling?

Use fewer products underneath, let each dry, and apply sunscreen in two thin layers, patting it on.

Does pilling mean a product is bad?

No. It's a layering problem, not a quality problem.

Which ingredients cause pilling?

Silicones, thickeners such as carbomer, film-forming humectants, and mineral filters are the commonest.

Is pilling the same as skin peeling?

No. Pilling is product; peeling is dead skin, and doesn't wash off.